To convert 1940–54 Knucklehead/Panhead cylinder head inlet fittings from plumber style to o-ring style manifold.

Insulator for Linkert carburetors as used by the factory on Panheads, however it will fit all Linkert applications using the 4 bolt mounting flange. It features an o-ring seal on both sides giving a superior seal between the intake manifold and the carburetor.

Reproductions of the stock hex head bolts to fasten Linkert carburetors to the manifold.

A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.