Accessories

In-line polarizing solid state adapters to convert your magneto to single-fire operation. Use one kit for for single or two kits for dual plug applications. With each set-up only the live cylinder fires. Works with all Harley magnetos.

The MRA is a revolutionary new device which aids starting by retarding the timing on fixed-position magnetos, helping to turn the infamous kick-backs and spit-backs into starts. When the cap-mounted lever is flipped, the points 'shift' 10 degrees, retarding your timing 20 degrees for starting. When the motor runs the lever is then locked in the advanced position by a rare-earth magnet. You'll love it! Fits clockwise turning Morris magnetos and other identically constructed magnetos like Joe Hunt, Fairbanks, etc. with cast housings.

Performance version of the magneto top cover with protruding terminals for a more secure fastening of the ignition wire leads.

Cute little kill button which replaces the standard ground wire terminal on Fairbanks, Hunt and Morris Magnetos. Now you just push the cap until it contacts the housing and the engine dies.

Replaces the factory mounting plate on Sportster models 1962-1964. Also required for magneto installation on Flathead engines.

Excellent reproductions of AMAL style handlebar levers for air/ignition control. They are very detailed and show excellent craftsmanship. Can be used to control your choke mechanism, ignition advance/retard, exhaust baffling discs etc. Cables have to be modified or fabricated. All versions are made to fit 1” handlebars.

This special condensor is necessary when running a magneto ignition without battery. Eliminates low-rpm light flickering.

Special, fully electronic voltage regulator which allows to run the bike without battery. Requires the use of a battery eliminator.

Back in the days it was common to carry a set of spare spark plugs easily accessible on the motorcycle. Thus in case of a necessary change you didn’t have to dig them up deep from the bottom of your saddlebags. These block-off plates with two threaded sockets derive from the race track and are intended for magneto equipped bikes without generator. They simply install in lieu of your genny and bolt down with the stock hardware.

Reproduction hold down bolts for magnetos and generators on IOE models.