DBBP Wave DIY Bars
- stainless steel / cast stainless steel, bare, riser distance 3-1/2” (= 89 mm)
- Ø 1”
- wire routing: W1 plain, without dimples (→1981)
- thread: 1/2”-20
- The Netherlands
Create your own Wave Bar design with these DIY handlebar components by DBBP/Mark van der Kwaak. The selection consists of 3-piece kits with low profile center piece and pre-bent bar ends and center pieces only for your own tubings. They directly bolt to the upper crown without risers.
Item №
Version
net price*
unit
Availability in warehouse Germany
* Tax free shipping.
Accessories:
See also:

Kustom Tech Handlebar Rings
With these handlebar rings you can achieve a smooth transition between grips and handlebars. Particularly recommended when installing Custom controls without switch housings. They mount easily on 1” handlebars with set screws.

Müller Throttle Grips for 1-1/8” ID Grips
Special grip assembly for routing and operating the throttle cable inside the handlebars. It shows German mechanical engineering at its best and features a spiral with two plain bearings and a plunger that is supported by double roller bearing pins for smooth, effortless and snap-back throttle control....

DBBP Wave Bars
A distinctive design and meticulous craftsmanship make these handlebars by the Dutch creative director Mark van der Kwaak stand out. With the cast center piece they mount very low on the upper triple tree for a sleek look. They directly bolt to the upper crown without risers.

LSL Drill Jigs for Handlebars
Handy tool for drilling handlebars when installing switches. Prevents drill from slipping and helps to correctly angle the drill bit. The jig is designed to work with 5 mm drill bits and to clamp on 1” handlebars. Professional quality.

Tolle Throttle Grips for 1-1/8” ID Grips
Many custom bike builders route cables and electrics inside the handlebars for clean appearance but unfortunately most twist grips were pretty hard to operate. Thanks to the Swedish company Tolle this basically good idea underwent a complete redesign which led to this ingenious product. Both spiral sleeve and plunger guide pin are supported by roller bearings which results in minimized friction and smooth, snap-back operation.

Hammer Sycle Handlebar Rings
Add a neat and classic style detail to your handlebars with these rings which will give your grips a true 1950's Hydra Glide appearance. They mount easily on 1” handlebars with set screws.

Have any questions?
Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: service@wwag.com