Handlebar »Wave DIY« by DBBP

With these handlebar rings you can achieve a smooth transition between grips and handlebars. Particularly recommended when installing Custom controls without switch housings. They mount easily on 1” handlebars with set screws.

Special grip assembly for routing and operating the throttle cable inside the handlebars. It shows German mechanical engineering at its best and features a spiral with two plain bearings and a plunger that is supported by double roller bearing pins for smooth, effortless and snap-back throttle control....

A distinctive design and meticulous craftsmanship make these handlebars by the Dutch creative director Mark van der Kwaak stand out. With the cast center piece they mount very low on the upper triple tree for a sleek look. They directly bolt to the upper crown without risers.

Handy tool for drilling handlebars when installing switches. Prevents drill from slipping and helps to correctly angle the drill bit. The jig is designed to work with 5 mm drill bits and to clamp on 1” handlebars. Professional quality.

Many custom bike builders route cables and electrics inside the handlebars for clean appearance but unfortunately most twist grips were pretty hard to operate. Thanks to the Swedish company Tolle this basically good idea underwent a complete redesign which led to this ingenious product. Both spiral sleeve and plunger guide pin are supported by roller bearings which results in minimized friction and smooth, snap-back operation.

Add a neat and classic style detail to your handlebars with these rings which will give your grips a true 1950's Hydra Glide appearance. They mount easily on 1” handlebars with set screws.