With these handlebar rings you can achieve a smooth transition between grips and handlebars. Particularly recommended when installing Custom controls without switch housings. They mount easily on 1” handlebars with set screws.

Create your own Wave Bar design with these DIY handlebar components by DBBP/Mark van der Kwaak. The selection consists of 3-piece kits with low profile center piece and pre-bent bar ends and center pieces only for your own tubings. They directly bolt to the upper crown without risers.

Handy tool for drilling handlebars when installing switches. Prevents drill from slipping and helps to correctly angle the drill bit. The jig is designed to work with 5 mm drill bits and to clamp on 1” handlebars. Professional quality.

Many custom bike builders route cables and electrics inside the handlebars for clean appearance but unfortunately most twist grips were pretty hard to operate. Thanks to the Swedish company Tolle this basically good idea underwent a complete redesign which led to this ingenious product. Both spiral sleeve and plunger guide pin are supported by roller bearings which results in minimized friction and smooth, snap-back operation.

This external throttle housing works with single cable and matches perfectly with the DELUXE handlebar controls. For retro-style handlebar projects.

Add a neat and classic style detail to your handlebars with these rings which will give your grips a true 1950's Hydra Glide appearance. They mount easily on 1” handlebars with set screws.