Create your own Wave Bar design with these DIY handlebar components by DBBP/Mark van der Kwaak. The selection consists of 3-piece kits with low profile center piece and pre-bent bar ends and center pieces only for your own tubings. They directly bolt to the upper crown without risers.
- stainless steel / cast stainless steel, bare, riser distance 3-1/2” (= 89 mm)
- thread: 1/2”-20
- wire routing: W1 plain, without dimples (→1981)
- The Netherlands
- gross weight: 1.54 kg
Kustom Tech Handlebar Rings
Müller Throttle Grips for 1-1/8” ID Grips
These Müller grips accept all rubber, plastic and aluminum grips with an 1-1/8” ID.
The mounting of handlebar end turn signals is possible and an additional inner brass tube protects the turn signal cable from being damaged from the plunger.
DBBP Wave Bars
LSL Drill Jigs for Handlebars
Tolle Throttle Grips for 1-1/8” ID Grips
Have any questions?
Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: email@example.com