Shop Electrical Relays
Relays Custom

Relays Custom

Toggle Relay
Toggle Relay
This relay opens one contact and closes the other one when activated. Can be used as opener or closer or to toggle between the contacts.
more …
Hi/Lo Beam Relay
Hi/Lo Beam Relay
This relay permits the use of a single push button at the handlebar to control the HI/LO beam function of your headlamp. The push button must switch to ground. With lights switched on you just touch the button to change between high and low beam. Especially recommended in conjunction with custom handlebar controls.
The use of a high beam indicator light is mandatory.
more …
MD Mini Relay Hi/Lo
MD Mini Relay Hi/Lo
This small relais by the German company Motorrad-Design allows high/low beam activation through push button switches. Hides easily in the headlight housing.
Use of a high-beam indicator light is mandatory.
more …
Bulb-mounted Hi/lo Beam Relays
Bulb-mounted Hi/lo Beam Relays
This module allows to flash the headlight or to switch between high and low beam with a single push button.The flash function works only with ignition switches that have different positions for ON and lights. Simply installs on bulb socket and hides in most any headlamp housing.
more …
motogadget mo.relay
motogadget mo.relay
A small, compact relay to switch almost any kind of electrical devices. It moves high loads and currents near the switched devices (e.g. your double headlamp), and significantly relieves the handlebar switches. Handle bar and ignition switches switch the low triggering currents only. This allows the use of small gauge wires at the switches. Damaged or burned contacts and wires will never happen again.
A threaded hole in the center of the housing enables fast and easy mechanical installation almost anywhere at the bike. The housing is absolutely water proof and vibration resistant.
more …
Starter Relais for StealthStarter Kick Drive and Pull Starter
Starter Relais for StealthStarter Kick Drive and Pull Starter
On the StealthStarter Kickdrive there's no built-in solenoid as on other Harley starter motors. In order for the high starting currents no to pass via the handlebar push-button, there's this here relay.
After extended market-research of the right part for our aims — which were not always completely non-destructive — we stayed with the one that we propose on this page. From a technical point of view this part is a true solenoid, the contact surface corresponding to an AGW 4 wire (~21 mm2). Since we equip the Cannonball StealthStarter with a slightlly smaller 16 mm2 cable, you are absolutely on the safe side with this relay.
more …
Hella Clip-On Socket Housings
Hella Clip-On Socket Housings
Socket housings that can be freely combined with and connected to each other. Makes for a very tidy harnesses.
more …

Relay for the not-so-original uses.

Exactly: Custom. Changer (insider tip: turn off headlight during electric start), relay for headlight up/down or miniature relay from motogadget and a starter relay for the Cannonball StealthStarter, which works without a solenoid switch.

Connection made easy

Nobody can remember all that. That's why you'll find hand-painted connection diagrams here in the store for all relays from Praktiker. Additional explanations are also provided in the caption. This makes wiring easy.

Have any questions?

Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: service@wwag.com