These are always missing or incorrect. Exact reproductions of the special screws and nuts to fasten the air intake cover to the backing plate.

Reproductions of screws and lock plates to mount the air cleaner backing plate to Linkert carburetors.

Chromed steel bracket to support round 8” accessory air cleaners from the Factory that many prefer to replace OEM ham can filters. Works of course for many other Custom applications.

The installation of a a CV carburetor with Custom air cleaner on a Panhead, Shovelhead or Ironhead Sportster involves two problems:
the protruding upper carb end interferes with the commonly flat backing plates of accessory air cleaners, omission of the stock CV air cleaner results in an unsupported carburetor,
This smart kit inludes a 3 mm spacer plate, which resolves the first problem and a flange adapter with two spiral springs to connect spacer and plate and thus safely hold the carburetor in its rubber flange = resolution of the second problem.
Will fit all motors with 2-bolt Tillotson, Bendix or Keihin (butterfly) manifolds. Installation also requires a 2-bolt flange adapter and a carburetor support bracket, which both need to be purchased separately.

To mount custom air cleaners with a flat backing plate on CV carburetors, the air filter backing plate must move further out, otherwise it will be in contact with the vacuum chamber. These spacers provide the required distance.

Combination of carb support bracket and breather system for CV carbs. Works with most custom air cleaners, carb covers and velocity stacks.

Chrome-plated carburetor support brackets for Big Twins 1984-up und Sportster 1986-up. Fit between carburetor and all flat air cleaner backing plates and mount to the stock mounting threads at the cylinder heads. Models equipped with the cylinder head breather system require an additional breather bolts.

These breather bolts are a great way to reduce your cylinder head vent fittings to a minimum.

These breather bolts are a great way to reduce your cylinder head vent fittings to a minimum.

Compilation of the parts which are required for the installation of custom air cleaners.

These kits are designed to support CV-Carburetors on models equipped with the cylinder head crankcase breather system, when mounting custom air cleaners that lack the support.

Unfortunately, almost all Harley-Davidson engines that vent the crankcase through the cylinder heads also expel oil through the same passages. Venting directly into the air cleaner, especially a free-flowing air cleaner, often results in an oily mess on the side of the bike. The Bluegrass Breather kit is a simple yet effective way to keep that oil inside the engine or at least keep it contained. The banjo fittings and chrome tubes route the vented gasses upward so gravity can keep any expelled oil droplets in the engine where they belong. Vent lines can be routed up and out of sight beneath the tank, but an optional catch tank is also available for those who would rather vent to a closed container.

Solve the problem when mounting a carb support bracket with a pair of these extra-long breather bolts, which you can simply cut to the required length.

Required when installing smooth-bore Mikuni carburetors HS 40 & HSR 42/45 on models with crankcase breathers that vent through the heads. Works with HSR 42/45 on Big Twin, Sportster and Buell models.

These inserts reduce the 1/2”-13 breather bolt thread to 5/16”-18, and come in helpful when you install later Evolution cylinder heads with ventilation to earlier engines with ventilation on the crankcase.

Crankcase breathers on performance bikes are prone to suck in debris, due to their enhanced respiratory capacity. This nice little filter keeps dirt outside the engine and the oil inside. Fits any 5/16” (8 mm) tube or connector, and - of course - not only racebikes.