Seats

A common problem with classic gas tanks - mostly difficult to correct and sometimes dangerous - is a leaking fuel valve due to distorted tanks and misaligned fuel valves. This period looking conversion kit for the 1940-1965 thru-the-tank gas valve helps to resolve this issue quickly and easily. The insert replaces the stock valve seat and accepts most 1/8” NPT, 1/4” NPT or 22 mm petcocks at the bottom. The rod is omitted, the crossover line can be retained. With the included cap you close the top of the tank. Now you can park your bike with peace of mind and without a gas puddle underneath.

An almost iconic custom part of the past is the Bates solo seat. Sleek looking and easy to mount it was and is the seat of choice for many choppers and bobbers. These reproductions are meticulously made after the period accessories, with no detail left out. This means the detachable leather cover is fixed to the correctly fabricated and zinc-plated base plate with Phillips screws and countersunk washers.

The perfect match for your Bates Tuck & Roll solo seats is one of these P-Pads. Handcrafted in from fine leather with a classy Tuck & Roll design. Slightly tilted towards the front, just like the period parts.

Chrome-plated mounting brackets for Custom solo seats.

Quality seat springs of German manufacture with unique features for a simple and safe installation. Both wire ends are laid in and have precision ground contact surfaces so the spring stays at a right angle when bolted down to the seat and bracket. An ID of 8 mm on one end and 11 or 15 mm on the other cover most situations. Available in two different spring rates.

When using large OEM style solo seats in custom applications this neat bracket holds your coil springs in the correct position and distance to be used with the LeBeeF or similar lower spring mounts.

Sometimes it's the little things in life that make the difference. Like this inconspicuous T-nut by Bates.
If you want to mount a sissy bar on Big Twin rigid frames 1936-1957, this is usually done at the mounting holes for the fender braces, which are located on the axle plates. The original mounting bolts are pushed through the axle plate from behind and secured from the front with a fairly large nut (wrench size: 5/8"). The problem is on the one hand, due to lack of space and mounting bolt length, the complete rear wheel as well as the brake base plate must be removed and on the other hand that the nut mounted from the outside leaves a rather bulky impression.
Bates T-nuts can be placed into the axle plate without removing the rear wheel and brake base plate. Additionally they are threaded, so the sissy bar can be mounted with a fairly plain 5/16“-24 screw. This gives the Harley-Davidson Chopper a much cleaner look. Two flats allow you to hold on to the T-nut with a 9/16“ open-end-wrench during installation.

In the 1970s motorcycle designers became more and more spirited and the familiar lines and appearance of two-wheelers were radically remodeled. Daring tank and seat combinations, mostly realized in fiber glass, soon freshened the bike scene and some ideas were even picked up by large manufacturers. The Beefy Body derives from a design by the legendary Californian company Tracy, which was an industry leader in this field back then. Gas tank, seat, side panels and rear fender form a single unit and completely transform the bike. Just add a fancy paint job and your scoot will stand out in the crowd, guaranteed. The whole body is made from fiber glass covered with a VE Flex gelcoat, which provides a smooth and clean surface for painting. The original fender struts can be omitted and the Beefy Body bolts directly to the frame. A seat base plate for building your own custom seat comes with it.