Shop
Handlebars
Grips
Grip Assemblies
Grip Control Conversion for Internal Cable
Calles Chopperdelar Throttle Grips for 1-1/8” ID Grips
Calles Chopperdelar Throttle Grips for 1-1/8” ID Grips
Price and stock:
Item №
21-639
Price incl. VAT
190.16 €
Available
7
Ready for immediate delivery from our Würzburg, Germany warehouse
The price includes 30.36 € German VAT.
- Throttle grip by Calles Chopperdelar
- for inside handlebars cable
- steel, bare
- length: 100 mm
- Ø 29 mm
- Sweden
- gross weight: 380 g
Lower priced alternative to the Tolle or Müller product. Does not have integrated roller bearings but is of sliding type. Still it works very well due to exact machining and close fit.
These spiral grips for internal throttle cables offered here do not work with aluminum throttle grips but require 1974-up rubber grips.
Accessories:

1942-1961 Waffle Style Grip Sets for Models 1974→

1962-1973 Ribbed Style Grip Sets for Models 1974→
Similar grips were factory equipment in the years 1962-1973. These custom versions are for handlebar and throttle assemblies 1974-up.

Do-It-Yourself Throttle Cables
Large selection of cable components to fabricate your own throttle cables to any desired length. These parts allow almost any combination of carburetors and handlebar controls.

Hammer Sycle Handlebar Rings
Add a neat and classic style detail to your handlebars with these rings which will give your grips a true 1950's Hydra Glide appearance. They mount easily on 1” handlebars with set screws.
See also:

Corotex 800 Fabric Tape
Versatile rayon fabric. Back in the days the factory used a very similar tape to fasten wiring harnesses to the frame and racers use it to cover handlebar grips for an improved grasp.

PanAm Pan-a-Grease
This little grease tube should be part of any tool roll to soothe squeaky joints and bearings, to ease stubborn pivots and much more. With its special lithium-based formula Pan-a-Grease provides long-term protection and lubrication.

Bates Throttle Conversion Kit for Linkert
A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.

Have any questions?
Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: service@wwag.com