Add a neat and classic style detail to your handlebars with these rings which will give your grips a true 1950's Hydra Glide appearance. They mount easily on 1” handlebars with set screws.

Versatile rayon fabric. Back in the days the factory used a very similar tape to fasten wiring harnesses to the frame and racers use it to cover handlebar grips for an improved grasp.

This little grease tube should be part of any tool roll to soothe squeaky joints and bearings, to ease stubborn pivots, lubrify sluggish cables, etc. With its special lithium-based formula Pan-a-Grease provides long-term protection and lubrication.

A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.