Grip Control Conversion for Internal Cable

Lower priced alternative to the Tolle or Müller product. Does not have integrated roller bearings but is of sliding type. Still it works very well due to exact machining and close fit.

Many custom bike builders route cables and electrics inside the handlebars for clean appearance but unfortunately most twist grips were pretty hard to operate. Thanks to the Swedish company Tolle this basically good idea underwent a complete redesign which led to this ingenious product. Both spiral sleeve and plunger guide pin are supported by roller bearings which results in minimized friction and smooth, snap-back operation.

Clean up your handlebars’ look by removing the external cable and routing it inside. These throttle grips feature a complete steel construction with internal PTFE components and bearing for a very smooth and fluid action. The outer diameter measures 1" and fits 1974→ original left grips as well as all 1” ID aftermarket grips.

Special grip assembly for routing and operating the throttle cable inside the handlebars. It shows German mechanical engineering at its best and features a spiral with two plain bearings and a plunger that is supported by double roller bearing pins for smooth, effortless and snap-back throttle control.
These Müller grips accept all rubber, plastic and aluminum grips with an 1-1/8” ID.
The mounting of handlebar end turn signals is possible and an additional inner brass tube protects the turn signal cable from being damaged from the plunger.