Experience a quantum leap in battery technology. The Micro-Start XP-3 is an ultra-small and extremely powerful Lithium-Ion power source and when we say small, we mean it fits in your pocket. Still it jump starts any car or motorcycle with 200 Amp jump starting ability, plus it is also powers or charges all your electronic devices such as iPads, cell phones, GPS, GoPro Cameras, MP3 players and everything else that can be charged via the USB Bus. Charge it once and take it with you anywhere and never again worry about getting stranded. Now you can easily take back-up power anywhere you go and not worry about coming back to a dead vehicle battery or having your cell phone run out of power when you need to make that important phone call. Just pull out your Micro-Start and get going again.
Features:

• 3 Power ports: a jump start port and two USB 5V output ports for charging or powering electronic devices
• Hi-Power LED flashlight with 2 flash patterns including an S.O.S. flashing beacon pattern
• 4 LED battery capacity indicator
• Over-charge and over-discharge protections
• Automatic power-off when not in use
• Detachable Mini Jumper Clamps
• Micro USB port for charging via USB cable

Terminal and thumb screw assembly which can be mounted on any suitable place on the motorcycle. It connects the battery’s ground (negative) terminal and cable with the frame.
After installation you have two options:

• use your Kill Bill Switch like an ignition switch. Half a turn out and the current is interrupted.
• use your Kill Bill Switch as protection from manipulation and theft. When you leave your bike remove the thumb screw and thus disconnect the battery from the electrical system.

Bahco battery chargers and maintainers are fully automatic and micro-processor controlled. Being of the "connect and forget" - type means that you hook them up to your motorcycle battery in periods of non-use and you need not care about the device until you want to go for a ride. The charger/maintainer will automaticcaly keep the optimum charge for your battery.
The device cannot be damaged by reversed polarity. It will automatically check the battery state and type and chose the appropriate charging program:

• Recovery
• Softstart
• Bulk mode
• Absorption
• Monitoring
• Float mode
• Maintain.

A practical hook on its back side allows for hanging it out of the way in convenient areas. Besides the common crocodile clips, the charger/maintainer comes with a 7.5 A fused harness with 6 mm ring connectors, that has a protected SAE plug.
A 3 LED charging stage display informs about the progress. The charger/maintainer works with any lead-based 6 V 6 Ah - 12 Ah or 12 V 12 Ah - 48 Ah vehicle battery. Max. output current is 2 A. The device is splashproof (IP 54).

Bahco battery chargers and maintainers are fully automatic and micro-processor controlled. Being of the "connect and forget" - type means that you hook them up to your motorcycle battery in periods of non-use and you need not care about the device until you want to go for a ride. The charger/maintainer will automaticcaly keep the optimum charge for your battery.
The device cannot be damaged by reversed polarity. It will automatically check the battery state and type and chose the appropriate charging program:

• Recovery
• Softstart
• Bulk mode
• Absorption
• Monitoring
• Float mode
• Maintain.

A practical hook on its back side allows for hanging it out of the way in convenient areas. Besides the common crocodile clips, the charger/maintainer comes with a 7.5 A fused harness with 6 mm ring connectors, that has a protected SAE plug.
A scrolling digital display provides step by step instructions to properly follow the charging of the battery such as “FULLY CHARGED AUTO MAINTAINING”, “CONNECT CLAMPS”, and “ANALYZING BATTERY”.
The charger/maitainer works with any lead-based or Lithium-Ion (LiFePo4), e.g. Antigravity, vehicle battery that has 12 V 6 Ah - 58 Ah. Max output current is 3 A. The device is sealed waterproof (IP 68).

Compact diagnostic charger and tester for 12V motorcycle lead acid batteries, incl. the maintenance-free gel-type batteries.
You can charge the battery directly as usually or select the program to charge via the 12V port on CAN-bus models.
The OptiMate 4 Dual Program is the ultimate all-in-one tool for 12V battery care at home, that diagnoses, recovers, charges, tests and optimally maintains your battery automatically until it is disconnected. This includes Low voltage pulse recovery for even more effective recovery of badly neglected, sulphated batteries; a user friendly battery test at connection; a slick weatherproof enclosure with built-in mounting lugs and improved energy efficiency.
Recommended for batteries in the 2 - 50 Ah range. The LED display with numerous indications informs about the operating state.

This compact battery charger features total epoxy encapsulation. It will constantly monitor, charge, and then maintain your battery, even while totally submerged under water! Perfect for all outdoor or wet situations like bike meets, camping or damp basements. Voltage input works anywhere in Continental Europe, 100-240 AC Volts 50/60 Hz.