An almost iconic custom part of the past is the Bates solo seat. Sleek looking and easy to mount it was and is the seat of choice for many choppers and bobbers. These reproductions are meticulously made after the period accessories, with no detail left out. This means the detachable leather cover is fixed to the correctly fabricated and zinc-plated base plate with Phillips screws and countersunk washers.

A bolt-on solution from LeBeeF for the front mounting of Custom solo seats with typical double front studs on basically all seat-post suited H-D frames. This ingenious device with hinge installs into your center frame tube which normally houses the seat post. It consists of a tube insert with attached hinge. The bushing has a thru-rod attached by which it is permanently tied down into the frame tube. A perfect solution for mounting solo seats if welding on an old stock frame is a no-no.

Quality seat springs of German manufacture with unique features for a simple and safe installation. Both wire ends are laid in and have precision ground contact surfaces so the spring stays at a right angle when bolted down to the seat and bracket. An ID of 8 mm on one end and 11 or 15 mm on the other cover most situations.

Coil type solo seat springs with a barrel type design.

Solo seat spring mounts which bolt to your frame after you drilled the frame cross tube or other spots. They come with a 1" coping to fit standard size frame tubing, but can be enlarged to fit larger tube if necessary. Sold as pairs.

Bare and clean custom version of the Sportster rear fenders from 1952-1978. In contrast to the original, this fender is manufactured without mounting holes, chain outcut and skirts at the edges and thus fulfills all requirements to work on it for an upcoming chopper project. Made for 18" and 19" wheels.

Mount your solo seat easily with these weld-on solo seat spring mounts. Made of easy welding steel, they are machined with a 1" coping to fit standard size frame tubing, but can be enlarged to fit larger tubes if necessary. They come as pairs with 1/8" thick leather washers to keep your springs from squeaking, as well as two spring cotter pins to hold your springs in place.