for Models 1910-1934

Perfect reproduction of the handlebar end screws used on models from 1910-1921.

These kits include all stock replacement parts which are essential for the restauration of your internal throttle and timer control plungers. Each kit includes rollers, pins and other small parts as pictured.

This is the tool you always wished to have when it’s time to loosen those frozen handlebar end screws. We all know that even the largest screwdriver in the average toolbox simply doesn’t do the job, because the slots in the end plugs are way too big and you will inevitably ruin them in no time. The Cyclery offers you the right stuff: hand forged and finished from tool steel with a substantial ironwood handle. The blade tip is hollow ground and 3/16” thick so it bites into the screw slot for a tight, non-slip fit. The version with 1/2” wide tip is intended for handlebars with hard plastic grips installed. Rubber grips can use the larger 5/8” type screwdriver. The shank has a 1/2” square section, which allows for support with an open end wrench. Classy tools for classic bikes.