Prism Supply Bristol Breather Carburetor Covers

A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.

A clean and and unobtrusive appearance are the decisive design features of this throttle grip by Prism Supply. The ingenious pulling mechanism consisting of a chain and carriage, allow for precise linear pulling actuation. Just a 90° twist will fully open your throttle (27 mm cable pull at the carb end). The clamp, polished to a high gloss, as well as the gas handle sleeve are made of aluminium. Suitable for all handlebars with 1" Ø and designed for all gas cables with snap ring (Ø 5/16”, 1996→). Throttle lock screw and grips must be ordered separately.

If you want to get rid of your footboards and are looking for a neat solution for discreet footpegs, you have just found it. These footpeg mounts are mounted directly on the footboard tabs of stock 4 speed Big Twin frames. Just the thing for a slimmed down chopper.

Unrestricted view of the engine, stylishly solved! The polished air filter cover is milled from one solid piece of aluminum and kept simple, clean and classic in design. A small velocity stack and a cone on the inside of the cover ensure optimum air flow and thus maximum efficiency with minimum size. With foam filter element.