Complete selection of individual replacement parts for Mikuni cran case breathers.

Instant period appearance. Add some classic style to your manifold clamps and replace the common socket head bolts with these authentic looking hex head bolts.

This Ironhead Sportster carb support bracket is made to bolt to your intake manifold and front intake tappet guide bolt. Will work with any carburetor.

Transparent lines which can be used as carburetor vent lines or overflow hoses. They are made from PVC.

High quality intake manifold clamps to replace the flimsy and troublesome stock clamps. They use a curved 10-24 threaded T-bolt with plated steel aircraft hex locknut.

Economically priced manifold clamps. Solid two-piece construction complete.

Rubber adaptors to mount spigot style carbs like Mikuni, Dell‘Orto, Keihin CV, etc. to manifolds with two-bolt flange.

These Mooneyes idle adjuster screws facilitate the adjusting of the idle speed and, with the cult Mooneyes ball, also cut a fine figure. The ball can be unscrewed and replaced with other Mooneyes valve caps.

These manifold clamps are cast from brass and precision-machined. The groove for the O-ring is exactly shaped and positioned where it is supposed to be for a perfect seal. Top notch quality! Delivered with a set of classic looking hex head screws.

Required when installing smooth-bore Mikuni carburetors HS 40 & HSR 42/45 on models with crankcase breathers that vent through the heads. Works with HSR 42/45 on Big Twin, Sportster and Buell models.

High quality intake manifold clamps to replace the flimsy and troublesome stock clamps. They use a curved 10-24 threaded T-bolt with plated steel aircraft hex locknut.

Aircraft-quality manifold clamps which provide a tight and strong fixation of the carburetor without extra support.

Aircraft-quality manifold clamps for Shovelhead Big Twin and Sportster models 1979-85.

Economically priced manifold clamps. Solid two-piece construction complete.

These transparent lines by Helix can be used as carburetor vent lines or overflow hoses. They are made from premium polyurethane with a Shore hardness of 85, which provides for superior resistance against abrasions, kink, tear, oxidation and chemical influences. It has a melting temperature of 188°C and an operating temperature range of -59° to +68°C. This line material will not get hard and stays flexible.

Required when installing smooth-bore Mikuni carburetors HS 40 & HSR 42/45 on models with crankcase breathers that vent through the heads. Works with HSR 42/45 on Big Twin, Sportster and Buell models.