Replacement Parts

Replacement Parts - general

more …

Choke Levers for Linkert Carburetors with Air Horn

The short choke lever which is used on Linkert carbs equipped with air horns or small deflectors.

more …

Choke Levers for Linkert Carburetors with 6”/7” Air Cleaners

Civilian type lever which is used on Linkert carbs equipped with round 6” or 7” air cleaners. The locking screw has to be ordered separately.

more …

Choke Levers Military for Linkert Carburetors

The military type lever which is used on Linkert carbs equipped with oil bath air cleaners or in custom applications. The locking screw has to be ordered separately.

more …

Mounting Screws for Linkert Choke Levers

Special screw that fixes the choke lever on its shaft.

more …

Low Speed Needle Levers for Linkert Carburetors

Lever for the low speed needle. When closing the choke disc on Linkert carburetors this lever will lift the needle and thus enrichen the mixture for cold start.

more …

The Cyclery Bowl Thread Repair Bushing

A common problem on Schebler DLX and Linkert M-series carburetors are stripped or damaged threads for the bowl nut. This repair bushing allows for a professional repair back to stock specs. Installation requires a lathe.

more …

Rebuild Kits for Linkert Carburetors

Complete kits which comprise all small parts to rebuild your worn Linkert carburetor. One part number and you are all set.

more …

Throttle Cable Nipples for Models →1975

Accurate reproductions of the throttle lever wire blocks used on all Linkert carburetors. Also fit Tillotson and Bendix carbs. The oversize version is for worn levers.

more …

Rubber Ducky Floats for Linkert Carburetors

These are absolutely the best and last floats you will ever buy for your Linkert Carburetor. The RUBBER DUCKY floats have been tested in the modern fuels available today that contain ethanol and various additives. Neither will they ever shrink nor corrode. Tests have also shown them to be reliable in 112 Octane Leaded Race Gas. RUBBER DUCKY Floats feature the correct weight and size so they can be set at the factory level which means they maintain the stock responsiveness and operation of your carburetor.

more …

Support Brackets for Linkert Carburetors

Exact reproductions of the original brackets used to support Linkert carburetors.

more …

CHP Linkert 4-Bolt Insulator Blocks

Cala's version of the thermal insulator first used on Panheads. Instead of being used between two gaskets it features a double o-ring seal thus providing a superior seal between manifold and carburetor.
Fits any Linkert 4 bolt application.

more …

Mounting Bolt Kits for Linkert Carburetors

Reproductions of the stock hex head bolts to fasten Linkert carburetors to the manifold.

more …

The Cyclery Linkert Air Cleaner Screws Oversize

Every second Linkert carburetor has one or more stripped threads for the air cleaner backing plate. Getting them repaired to the stock #12-24 thread is not easy but these oversize thread screws solve the problem in no time. You just tap the stripped thread to 1/4”-20 and you're done. The 3/8” hex head is like stock so once installed you can't see a difference.

more …

Colony Linkert Air Cleaner Screws

more …