Replacement Parts

Replacement Lenses for Headlight 1920-1928
Replacement Lenses for Headlight 1920-1928
more …
Replacement Lenses for Bullet Headlight 1929-1930
Replacement Lenses for Bullet Headlight 1929-1930
more …
Replacement Lenses for Headlight Motolamp 1931-1934
Replacement Lenses for Headlight Motolamp 1931-1934
more …
Replacement Bezels for Bullet Headlight 1929-1930
Replacement Bezels for Bullet Headlight 1929-1930
more …
Replacement Bezels for Bosch TS 150 Headlight
Replacement Bezels for Bosch TS 150 Headlight
more …
Replacement Parts for Springer Headlights 6-1/2”
Replacement Parts for Springer Headlights 6-1/2”
more …
Repair Kit for Springer Headlights 6-1/2”
Repair Kit for Springer Headlights 6-1/2”
Great kit for the restoration of classic Springer headlights. Inludes special carriage screws to replace lose or lost rivets and other small parts for wire terminals, bezel and bottom mount.
more …
The Cyclery Terminal Blocks for Springer Headlights 6-1/2”
The Cyclery Terminal Blocks for Springer Headlights 6-1/2”
Terminal Block for headlight housing with threaded sockets and 4 slotted roundhead screws. The low-beam wire from the handlebar switch goes to the #8 screw and high beam attaches to the #10 screw, same on the inside. This way, for removing the headlight, only two wires on the outside of the headlight bucket have to be disconnected.
more …
Replacement Parts for 7
Replacement Parts for 7" Hydra Glide Headlight
more …
Buttonhead Phillips Screws Zinc Plated
Buttonhead Phillips Screws Zinc Plated
more …
Replacement Parts for Headlamp Housing for FLH/Servi-Car 1960-1984
Replacement Parts for Headlamp Housing for FLH/Servi-Car 1960-1984
more …
Replacement Parts for FX and Sportster Style Headlight and Housing
Replacement Parts for FX and Sportster Style Headlight and Housing
more …
The Cyclery Bulb Bases for Headlights 1926-1928
The Cyclery Bulb Bases for Headlights 1926-1928
These bayonet bulb bases are for original headlights of models 1926-1928. The filaments of these bulbs were — due to technical reasons — not always in the focal point of the reflector. Therefore, the focus of the light beam usually had to be re-adjusted after a bulb exchange. The The Cyclery bulb bases with their spring-loaded adjusting screw take care of this job. The wire cores are clamped with a set screw each.
more …
The Cyclery Sleeve Nuts for Headlights and Taillights 1920-1928
The Cyclery Sleeve Nuts for Headlights and Taillights 1920-1928
more …

Have any questions?

Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: service@wwag.com