Add some true vintage style to your handlebars with a set of Retro brake and clutch levers by Kustom Tech. They feature an inverted design which allows to run your brake and clutch control cables inside the handlebars. Cables have to be modified or fabricated. A sturdy cylinder clamp holds the levers safely inside the tube. All versions can be installed left and right.

These clamps with integrated microswitch fit all DeLuxe line and Classic line master cylinders and clutch/brake lever assemblies by Kustom Tech.

Handlebar grips on race bikes of the vintage years were wrapped with fabric in order to improve the grip at the bars. Kustom Tech’s “Fabric Style“ grips are covered in the same way. The sleeves proper are machined from billet aluminum and polished for models 1974-up with internal throttle cable which feature right side sleeves of 1” (25,4 mm) OD.

Handlebar grips on race bikes of the vintage years were wrapped with fabric in order to improve the grip at the bars. Kustom Tech’s “Fabric Style“ grips are covered in the same way. The sleeves proper are machined from billet aluminum and brass.

This little grease tube should be part of any tool roll to soothe squeaky joints and bearings, to ease stubborn pivots, lubrify sluggish cables, etc. With its special lithium-based formula Pan-a-Grease provides long-term protection and lubrication.

Handlebar grips on race bikes of the vintage years were wrapped with fabric in order to improve the grip at the bars. Kustom Tech’s “Fabric Style“ grips are covered in the same way. The sleeves proper are machined from billet aluminum and brass.

The lever design of these beautiful Kustom Tech Deluxe brake and clutch controls derives from the 1930’s and perfectly combines retro looks with modern technology. Brackets and master cylinder reservoirs are made of forged aluminium, with your choice of brass or aluminum levers and cover plus a satin, black or polished finish. Kustom Tech Deluxe controls fit all 1" handlebars.

A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.

Beautiful, nostalgic looking risers from Italy.

These beautiful grip sets feature billet brass rings.

The design of Kustom Tech’s Classic line handlebar controls is of timeless beauty and looks right at home on many styles of bikes. Clutch and brake sides are perfectly matched with your choice of cable or hydraulic operation. Cable operation assemblies come with 2 cable pins for early and late style cables.