Burly Apehanger Cable and Line Kits
- Cable and brake line kit by Burly Brand
- fits Dyna FXD/B/C/L/WG/ 2012-2014 (with ABS)
- single disc
- steel / vinyl / copper / plastic, black, satin finish
- maximal height of handlebar: 35 cm
- clutch cable (inner cable): 202 cm
- throttle and idle cable (inner cable): 119 cm
- brake line (banjos, center to center): 82.5 cm / 53 cm
- wiring harnesses: 38.5 cm
- with instructions
- without approval marks
- gross weight: 1.49 kg
If you love the look of Apehangers, but hate sorting out which cables and brake line to use, you will like these complete cable/line control kits. No more trial, error and inventing of bad words that used to accompany mounting a set of Apehangers. Each kit is specific to a year range and bar height and includes extended throttle cables, extended clutch cable, extended brake line and even wiring harness extensions. One part# and you are all set.
Burly Brand Cable and Line extension kits for H-DLAN aka CAN-bus equipped models contain two small harnesses for the handlebar control units. Burly recommends to cut the OEM connectors and to solder the extension wires to the OEM wires.
W&W Cycles does not recommend to do so unless you are a real expert in soldering of electronic components. The better and faster way for most will be to buy the corresponding MX19 pin housings and pins:
WW 14-523 (two way housing), 14-524 (four way housing) and 14-546 (pins). Crimping electronic component connectors will be a snap using the right tool: WW 84-280 (PA-20 crimp tool).
Have any questions?
Our service team will be glad to help out: Mondays - Thursdays 08:00-17:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: service@wwag.com