>for Custom Use
>PM Contour Single Cable Throttle Housings
Cable elbow by Barnett; for Throttle cable; steel, chrome-plated, PTFE liner; elbow angle: 130°; top end fitting: 5/16"-18; USA; gross weight: 3 g
This little grease tube should be part of any tool roll to soothe squeaky joints and bearings, to ease stubborn pivots, lubrify sluggish cables, etc. With its special lithium-based formula Pan-a-Grease provides long-term protection and lubrication.
Bates Throttle Conversion Kit for Linkert
A custom part with a long tradition. This smart little device allows for the use of pull type throttle assemblies with Linkert carbs. After installation the throttle disc will be pulled to open and the spring closes it again, when you release the throttle grip. Each kit comes with two springs to meet individual requirements. The weaker spring (Fn≈23 N) should be sufficient for most outside cable applications, the stronger spring (Fn≈58 N) is recommended for internal or very long throttle cables. Works with all M-series Linkert carbs, when equipped with a 1949-1965 type lever, i.e. OEM# 27260-49.
Have any questions?
Our service team will be glad to help out: Mondays - Thursdays 09:00-16:00 CET, Fridays 08:00-16:00 CET, Phone: +49 / 931 250 61 16, eMail: email@example.com