The shape of these handlebars is inspired by the legendary Tramp I, a Knucklehead drag bike built by S&S founder George Smith in the early Fifties. They feature distinctive, pulled-down tube ends. This feature helps so much when crouching down on the tanks during your quest for top speed. The selection includes handlebars for stock spiral grips thru 1948 and handlebers which feature straight 1” tubing on both ends so they will accept 1974-up grips and clamp type throttle controls.

Authentic reproduction of the rear fender as it was used by the factory on WR race bikes. With chopped off rear section and trimmed sides. Perfect for your Bobber or Scrambler project.

Authentic reproductions of the original WR gas tanks as used on the 1946-1952 production race bikes of the same name. The narrow shape and omission of the speedo assembly achieve that much sought after racy look.

Standard equipment on the Flathead street racing model, the WRTT. Actually not a muffler because it has no restriction whatsoever and is therefore allowed for use on racetracks only.

There is NO Substitute for more cubic inches! Boost your little Flatty up to 54 cui or 900cc and experience the change from a lame duck to an agile pony. These 4.5” stroker flywheels require special stroker pistons which are also available. Recommended for qualified mechanics only because the flywheels need to be balanced and the engine cases and cylinders must be relieved for the rods to clear....